BRP Evinrude Spécifications télécharger pdf (Page 37)

OUTBOARD INSTALLATION

TRANSOM MEASURING AND DRILLING

Before drilling any mounting holes:

• Make sure the hole locations provide enough

clearance for mounting bolts and washers.

• Check the inside area of the transom for

obstructions.

• Check transom height(s) at centerlines.

Drill four ½ in. (13 mm) mounting holes in the

appropriate locations.

IMPORTANT: Be sure to drill the required holes

perpendicular to transom surface.

40–65 HP, MANUAL TILT MODELS

25–30 HP, MANUAL TILT MODELS

15 HP, POWER TILT MODELS

Center the outboard on the transom (or mounting

bracket) and tighten clamp screws by hand.

Use each stern bracket’s mounting holes as a

guide to drill holes through the transom.

• 40–65 HP models require four 5/16 in. (8 mm)

holes

• 25–30 HP models require two 5/16 in. (8 mm)

holes

• 15 HP models require four 5/16 in. (8 mm)

holes.

40 – 65 HP Models 002215

25 – 30 HP Models 007998

15 HP Models 007999

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 101 102

Pas de commentaire

BRP Evinrude Spécifications Page 37