BRP Evinrude Spécifications télécharger pdf (Page 69)

OUTBOARD RIGGING

EVINRUDE E-TEC MODELS 40–90 HP

SystemCheck Harness

Connections

Place the wiring harness through notch in lower

motor cover and route to the recess in the fly-

wheel cover. Secure the cable with a tie strap as

shown:

Before installing electrical connectors, check that

the seal is in place. Clean off any dirt from con-

nectors. Apply a light coat of Electrical Grease to

the seal only. DO NOT fill connectors with Electri-

cal Grease.

Arrange connectors in flywheel cover.

Install electrical cover and secure with screws.

BE SURE all harnesses and wires

are not pinched, cannot contact flywheel, and

do not interfere with moving throttle or shift

linkages.

1. Recess

2. Tie strap

002011

1. Seal 42079A

001999

002102

NOTICE

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 101 102

Pas de commentaire

BRP Evinrude Spécifications Page 69